Advertisement
Adding Optional Sections
34.
Cone Hinge
1
2
35.
36.
16
Top hinge
35a
Top hinge
36a
Top hinge
An extension has a top hinge in one end and
a cone hinge in the other. This makes it pos-
sible to fit the extension to all kinds of
sections.
The removable, vertical bar has already been
fitted by the manufacturer. Remove this bar
by lifting it up (1) and sliding it out of the
lower hinge (2).
To avoid rearranging the caps/covers/cones,
add extensions according to the next illustra-
tions.
ConfigureGate
Separate the gate between door and section
(see ill. 35) by removing the removable, verti-
cal bar.
Fit the extension by placing the top hinge on
the door section over the cone hinge of the
extension (see ill. 35a). The hinges must be
aligned both on top and bottom.
Let the hinges drop together and insert the
removable, vertical bar.
Fit the last section in the same way.
HearthGate
Separate the gate between two sections (see
ill. 36) by removing the removable, vertical
bar.
Fit the extension by placing the top hinge of
the extension over the cone hinge of the sec-
tion (see ill. 36a). The hinges must be aligned
both on top and bottom.
Let the hinges drop together and insert the
removable vertical bar.
Fit the last section in the same way.
Advertisement
