Advertisement
Setting up the HearthGate and ConfigureGate
21.
Centre vertical
bar
22.
(2)
23.
24.
12
21a
(3)
(1)
22a
Press down
Top hinge
Lift up
Cone hinge
Top hinge
Bottom hinge
24a
(1)
(2)
Fit vertical bar
Place the folded gate on a stable surface
with the handle facing up.
Separate the HearthGate in two parts by pul-
ling up in the centre removable, vertical bar
(see ill. 21) and let it slide out of the groove
of the bottom hinge (ill. 21a).
Unfold the sections:
At the corner, lift up slightly on the section
with hinge teeth facing down (1) while gently
pressing down on the connected section (2).
Rotate the section (3).
Unfold the gate to the desired shape.
Unfold both parts and align the end section
with cone hinge underneath the end section
with top hinge (ill. 23) - be sure that the
hinges engage both on top and on bottom
(see circle drawings of ill 23).
Connect the two parts by pushing the remo-
vable, vertical bar up into the upper hinge (1)
and let it slide into the groove (2).
• If adding sections - go to page 16.
• If gate is too long - go to page 17.
• If making no changes - continue with
fitting the wall fittings on next page.
Advertisement
