Advertisement
Fitting the Wall Fittings
25.
a
c
b
26.
27.
28.
d
25a.
d
max
15 cm
(6")
Assemble lower bar brackets (b) and slides
(c) with screws and nuts as shown. Tighten
screws just enough to allow parts to slide
easily. Slide wall plates (d) onto back of
upper and lower bar brackets (a and b) until
click is heard and locked in place.
Place upper bracket around top cone hinge.
Slide lower bracket assembly onto
removable bar and push bar up into upper
bracket. Repeat for opposite side of gate.
Move ConfigureGate to desired location.
Rotate upper and lower brackets until flush
against mounting surface. With a pencil, out-
line brackets on mounting surface.
NOTE: Lower bracket is adjustable. It can be
moved up (maximum 15 cm (6")) to accom-
modate various heights of floor molding; and
by loosening screw, can adjust widths to
accommodate uneven wall construction.
13
Advertisement
