Marantz RC5000i User Manual page 6

Introduction
2 Remove the AA tray if necessary
(see step 2, page 5).
3 Insert the battery pack (included
with the RC5000i but an optional
accessory with the SR14EX) as
indicated on the side of the
battery pack.
4 Slide the battery door back on.
After a few seconds, the RC5000i starts up automatically and
beeps twice to indicate that it is ready to use.
When batteries are running low, the Low Battery icon
the center top of the display. Recharge or replace the batteries as
soon as possible to ensure perfect performance.
Note
Recharging Dock
Warning
1 Plug the power adapter into
a wall outlet and connect it
to the recharging dock.
2 Place the RC5000i
on the recharging dock.
Recharging starts automatically.
The light on the front of the re-
charging dock lights up constantly while normal charging occurs.
When the battery pack is fully charged, the light goes off.
Should the light blink, see Troubleshooting on page 51.
Notes
User Guide
The RC5000i retains all settings when batteries have run out or
when you replace them. You will only have to reset the clock.
Use the recharging dock only with the Philips NiMH
rechargeable battery pack.
· You can operate the RC5000i while it is being charged.
· Normal charging time is 2 to 3 hours, depending on the
condition of the battery pack.
4
flashes at