Advantech SmartStart Series Start Manual page 13

3. Power
The router requires an external DC power supply. The DC voltage required is between
+10 to +60 V DC. The router has built-in protection against reverse polarity without signaling.
Connect the power supply cable to the PWR connector on the router's front panel; see the
figure below.
4. Ethernet
For an initial configuration made in a web browser, connect a PC by an Ethernet cable to
the default LAN interface, use the ETH0 port; see the figure above. By default, this interface
has the following configuration:
Connector Purpose
ETH0 LAN port (default)
Connect your PC to this port to get the
router web interface.
Configuration
1. Configuring the Device Using the Web Browser
You can use a web browser running on your PC to access the router web interface. Here
you can perform router monitoring, configuration, and administration. First, connect the PC to
the default LAN interface described in the Ethernet chapter. To get the router interface, enter
the
https://192.168.1.1
protocol for secure communication over the network is required.
There is just the extbfroot user account created on the router by default. See the product
label on the router for its default password
and his password. See the configuration manual of the router for a detailed description and
examples of the router configuration.
2
If the label does not contain a unique password, use "root" string as the password.
QSG-0002-EN, March 3, 2022
address in a web browser. Please note that usage of the HTTPS
2
. Log in to the web interface by the root user
12
SmartFlex
Default Setting
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
Released in the Czech Republic