Inventory - Grizzly G0714 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Inventory (Figures 2–3)
A. Blast Cabinet Assembly ............................. 1
B. Dust Collector ............................................. 1
C. Left Work Table .......................................... 1
D. Right Work Table ........................................ 1
E. Hopper Support .......................................... 1
F. Hopper ........................................................ 1
G. Legs ............................................................ 4
H. Light Window Adhesive Film 35
I.
Viewing Window Film 26" x 12" .................. 5
J. Blast Tip Set ............................................... 1
—Blast Tip 6mm ID .................................... 2
— Blast Tip 7mm ID .................................... 2
K. Teflon Tape (Pipe Fittings) .......................... 1
L. Regulator & Foot Valve w/Hoses ............... 1
M. Leg Supports (43 ⁄
3
4
N. Leg Supports (32
⁄
1
4
O. Bolt Bag ...................................................... 1
—Hex Bolts M8-1.25 x 20 (Stand) ........... 32
— Flat Washers 8mm (Stand) ................... 32
— Lock Washers 8mm (Stand) ................. 32
— Hex Nuts M8-1.25 (Stand) .................... 16
—Phillips Head Screws M6-1 x 16
(Hopper) ................................................ 22
— Flat Washers 6mm (Hopper) ................ 22
—Cabinet Screws M6-1 x 12 (Regulator) .. 2
— Flange Nuts M6-1 (Regulator) ................ 2
—Cabinet Screws M6-1 x 12
(Dust Collector) ....................................... 4
— Flange Nuts M6-1 (Dust Collector) ......... 4
-12-
Qty
⁄ " x 10".... 5
1
2
") ................................. 2
") ................................. 2
F
Figure 2. Main inventory.
I
G
M
N
Figure 3. Small items inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0714 (Mfd. Since 05/22)
A
B
C
D
E
J
H
K
L
O