Grizzly G0714 Owner's Manual page 37

12. Place brush housing into brush seat on
motor, and place retainer over brush hous-
ing so lock lug drops into lock slot in brush
housing (see Figure 41).
Lock Slot
Figure 41. Brush retainer installation.
13. Install and tighten brush housing retaining
screws.
14. When brush housings are installed, make
sure to route brush power wires well away
from commutator, as shown in Figure 42, or
commutator will wear into wire, causing elec-
trical short.
Incorrect
Figure 42. Safe power wire routing.
Model G0714 (Mfd. Since 05/22)
Lock Lug
Correct
15. Place fan cover back onto motor so tangs lock
onto brush housings, as shown in Figure 43.
Tangs
Figure 43. Fan cover installation.
16. Install motor cover and insert dust collector
assembly into canister, then latch dust collec-
tor in place.
17. Test dust collector operation as outlined in
Test Run on Page 21.
-35-