Grizzly G0714 Owner's Manual page 39

8.
With help of assistant, place LED housing on
top of cabinet, facing upwards, as shown in
Figure 47.
Figure 47. LED housing facing upwards.
9.
Lift sheet of glass off cabinet, and set it on
workbench for cleaning.
10. Disconnect any cords attached to LED you
want to replace, and remove LED (see
Figure 48).
Note: LEDs are held in place by spring
clamps.
Cord
(1 of 3)
Figure 48. Cords attached to LEDs.
11. Install new LED and connect to cord(s) dis-
connected in Step 10.
Model G0714 (Mfd. Since 05/22)
LED
(1 of 3)
12. Connect machine to power and toggle LIGHT
switch to ON position to test new lights.
— If all lights light quickly without much flick-
ering or lag, lights are fully functional.
— If any lights struggle for more than five
seconds, are dim, or do not light, check
cord/wire connections.
Note: Refer to wiring diagram on Page 39 if
you are unsure about wiring connections.
13. DISCONNECT MACHINE FROM POWER!
14. Inspect window seal and its surface for evi-
dence of dust streaking between glass and
seal, and cabinet and seal.
Make sure that seal is free of any physical
damage. Replace or reseal accordingly, but
never use glue, caulking, or silicone of any
kind between window and its seal, as this will
permanently fasten glass to cabinet. Seal is
established my means of vacuum created by
dust collector.
15. Peel off old adhesive window protection film
from glass window.
16. Using paint brush with solution of warm water
and dish soap, rinse all dust and abrasives
off of window. Do not rub glass with rag or
abrasives will scratch surface.
17. Use mineral spirits to break down any adhe-
sive residue leftover from protective film.
18. Clean window with glass cleaner and soft cot-
ton rag.
19. When window is fully dry, affix new protective
film.
20. Re-assemble cabinet in reverse order, mak-
ing sure to install glass window so protective
film is toward inside of blast cabinet.
-37-