Table of Contents
Advertisement
3.3
INSTALLATION PROCEDURES
3.3.1 GOODS INWARDS INSPECTION
This system was factory tested, inspected, packed, and delivered to the carrier with utmost care. Do
not accept shipment from carrier which shows damage or shortage until the carrier's agent endorses
a statement of the irregularity on the face of the carrier's receipt. Without documentary evidence, a
claim cannot be processed.
Open and check each package against the packing list. For any shortage, contact Comba Telecom
Systems. Do not remove items from packing materials until installation.
3.3.2 TOOLS
See appendix for a full list of tools required for installation and maintenance.
3.3.3 PREPARATION
•
Mounting surface capable of support equipment's weight.
•
Power outlet within 2m
•
Terminate unused antenna/RF cable with 50 ohm terminator
•
Protect unused optical interface with protective cap
•
Earthing point/Safety ground within 2m
Antenna:
•
Antenna installation is covered by their respective manuals. Take normal precautions when
preparing and handling feeder cables to ensure they are not damaged.
Optical Fiber:
•
Fiber optic cables require proper handling. Do not stretch, puncture, or crush the fiber cable(s)
with staples, heavy equipment, doors, etc.
•
Always maintain the minimum bending radius specified by the cable manufacturer. The minimum
bend radius is usually 10 times as the cable's outer diameter. In the case of single optical fiber
that is not in a cable, the minimum bending radius to be observed is 3cm.
RA-7800 QI
ENU Status : 1-0-1
INSTALLATION GUIDE FOR RA-7800
Copyright - refer to title page
Page 27
Advertisement
Table of Contents
Need help?
Do you have a question about the RA-7800 and is the answer not in the manual?
Questions and answers