Ethernet Network Configuration - IBM 7199-92X Installation And User Manual

Note: When you press the power button to turn off the appliance, there is still

Ethernet network configuration

The Ethernet modules expand the network connectivity options. Each appliance
has two Ethernet modules. The Ethernet modules are numbered from left to right,
but if a module has less than eight ports, the module will use the lowest port
number in the range.
Numbering convention
The numbering convention for configuring Ethernet interfaces and installing
network cables is:
v Left module ranges from ETH0 to ETH7
v Right module ranges from ETH8 to ETH9
Type 7199 connections
Each Ethernet module has one of the following configurations:
v The left Ethernet module has eight 1 Gigabit Ethernet ports, which are RJ45
v The right Ethernet module has two 10 Gigabit Ethernet ports, which are small
The appliance has ten Ethernet connections. The Ethernet interface names are ETH0
through ETH7, ETH8, and ETH9.
Figure 5. 8x2 Ethernet connection
8
WebSphere DataPower XC10 Appliance: Type 7199-92X: Installation and User's Guide
electrical current flowing to the device. To completely stop all electricity to
the appliance, unplug all power cords.
connectors.
form-factor pluggable (SFP+) transceivers.