DeLonghi Eletta Evo ECAM4686X Instructions For Use Manual page 23

PROBLEM
The coffee is delivered too
slowly or a drop at a time.
The LONG coffee is too creamy The coffee is ground too finely.
The appliance will not make
coffee
Coffee does not come out of
one or both of the spouts.
The appliance does not come
on
The infuser cannot be removed The appliance has not been turned off correctly Turn the appliance off by pressing the
At the end of descaling, the
appliance requests a third
rinse
Milk does not flow from the
milk spout (D3)
The milk contains large
bubbles and squirts out of
the milk spout (D3) or there is
little froth
The machine emits noises or
small puffs of steam while not
in use
POSSIBLE CAUSE
The coffee is ground too finely.
The appliance has detected impurities in its
internal circuits. "Please wait" is displayed.
The coffee spouts (A9) are blocked.
It is not plugged into the mains socket.
During the two rinse cycles, the water tank
(A14) has not been filled to the MAX level.
The milk container lid (D1) is dirty
Make sure the milk intake tube (D4) is correctly
inserted in the bottom of the milk container lid
(fig. 14)
The milk is not cold enough or is not semi-
skimmed or skimmed
The froth adjustment dial (D1) is incorrectly
adjusted.
The milk container lid (D1), froth adjustment
dial (D1), or milk intake tube (D4) are dirty
The hot water connection nozzle (A10) is dirty Clean the connection nozzle as described in
The machine is ready for use, or has recently
been turned off, and condensate is dripping
into the hot vaporiser
REMEDY
Turn the grinding adjustment dial (A5) one click
clockwise towards "7" while the coffee grinder
is in operation (fig. 11). Continue one click at
a time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see section "7.4 Adjusting the coffee grinder").
Turn the grinding adjustment dial "A5. Grind-
ing adjustment dial" one click clockwise
towards "7" while the coffee grinder is in op-
eration (fig. 11). Continue one click at a time
until coffee delivery is satisfactory. The effect
is visible only after 2 coffees have been made.
Wait for the appliance to be ready again and
reselect the required beverage. Contact cus-
tomer services if the problem persists.
Clean the spouts with a toothpick (fig. 23).
Plug into the mains socket (fig. 1).
button (A7) (fig. 9) (see section "5. Turning the
appliance off").
Follow the instructions displayed by the appli-
ance, but first empty the drip tray (A19) to avoid
the water overflowing.
Clean the milk container lid as described in sec-
tion "11.10 Cleaning the milk container".
Insert the milk intake tube as far as it will go
Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5°C). If the result is
not as you wished, try changing brand of milk.
Adjust following the instructions in section
"8.2 Adjust the quantity of froth".
Clean the milk container lid, dial and milk
intake tube as described in section . "11.10
Cleaning the milk container".
section "11.11 Cleaning the hot water nozzle".
This is part of normal operation. To limit the
phenomenon, empty the drip tray.
23