Fix The Dsc Label; Connect The Radio Cables - Lowrance LVR-250 Installation And Operation Instructions Manual

Fix the DSC label

A DSC warning label is supplied with the LVR-250. To comply with FCC regulations, this
warning label must be affixed in a location that is clearly visible from the operating con-
trols of this Lowrance radio. Make sure that the chosen location is clean and dry before
applying this label.

Connect the Radio Cables

The connectors are on the rear of the base unit, as follows:
GPS/COM connector.
1.
for wiring and color codes. (If you're not using this, be sure to put the protective cap
securely over the connector to protect it from moisture and dust.)
External Speaker connector.
2.
BEFORE powering on the radio. Use a 4 Ohm 4 Watt external speaker.
Red Power wire.
3.
fuse is installed on this power cable close to the battery.
Black Power wire.
4.
ANT.
5. A radio antenna is not supplied. A suitable radio antenna must be mounted
and connected before operating the LVR-250 radio. Consult your dealer for advice if
necessary.
GND.
6. A ground connection is not usually required.
1
2
3
4
10
For connection to GPS device via NMEA. See the following table
Plug the external speaker cable jack into the connector
Connect this to the Positive (+) battery terminal. Check that a 10 Amp
Connect this to the Negative (-) battery terminal.
Lowrance - LVR-250 Installation and Operation Instructions
CAUTION
5
6