Advertisement
Installation (cont.)
Lift the panel to determine the proper height and placement. It is recommened
to aim the top horizontal body jet to the chest area for optimal showering experi-
ence.
440mm
17.32"
1"
Decor Star
3. Install hand shower connector and
attach PVC tubing to complete the con-
nection on the shower panel.
4. Mark the positions of the 2 brackets
on the wall and set a side the panel.
(NOTE: The distance between the two
brackets should be 17.32" or 440 mm)
5. Using a drill with a tile bit, drill the
hole slowly into the tile. Do not drill into
any piping or wiring in the wall. Insert
the anchors into the wall. (NOTE: Before
installing the wall anchors, use a small
piece of painters tape or masking tape
over the drill area. This will prevent dam-
ages to the tile)
5
Installation (cont.)
A
B
C
D
6. Secure the mounting brackets to the
wall.
7. Hang the unit on the wall. Make sure
the unit is seated properly. Apply silicon
sealant on both sides of the shower pan-
el to complete the installation. (NOTE:
do not seal the bottom of the panel, this
will allow any possible future leaks to
drain out the panel)
8. Disassemble the water supply hose
assembly by loosen the compression
nut (C),remove compression ring (B)
and pull out the elbow connetor (A)
6
PL-011-GS Rev. A
082013
Advertisement
