Advertisement
Installation (cont.)
A
B
C
D
A
B
Decor Star
9. Measure the length needed for the
main water supply hoses. Trim off the
excess PVC tubing.
10. After the excess hose has been
trimmed. First slip compression nut
(C) and the compression ring (B) onto
the PVC hose (D). Insert the elbow
connector (A) into the hose. Push the
compression ring (B) up toward the end
of the hose as far as possible. Tighten
the compression nut (C) (NOTE: Do not
over tighten the nut as it may damage
the seal and causes leaks)
11. Wipe the surrounding surface around
the pipe free of dirt and debris. Peel off
the adhesive backing of the cover base
(A) and press it firmly against the wall to
ensure a tight bond. Apply some PTFE
tape on the pipe threading. Connect the
main water supply hose assembly to the
pipe. (NOTE: Do not over tighten the nut
as it may damage the seal and causes
leaks) Once the connection is made, in-
stall the cover over the elbow connector.
7
Installation (cont.)
12. Connect hand shower hose to the
main panel body. Install the rubber
washer.
13. Attach the hand shower to the hose.
8
PL-011-GS Rev. A
082013
Advertisement
