Table of Contents
Advertisement
Installing Multiplexers
Configuring the DS3 Transport through the HXU-357
The DS3 transport is configured in accordance with network requirements.
Step
Procedure
1
From the Configuration Management submenu, press
DS3 Interface.
For more information on navigating through the menu system, refer to the procedures detailed in
"Setting Up the Communications Channel through the HXU-357" on page
2
Configure the DS3 transport according to CO requirements. Select each of the following setting
options by typing its number, then choosing one of the parameters listed for that option.
1
Configure DS3 mode
2
Configure DS3 line buildout
3
Configure DS3 transmit timing
4
Configure DS3 BER threshold
+
3
Press
CTRL
R
to return to the Configuration Management submenu.
4
Proceed to
"Placing the DS3 Transport In Service through the HXU-357" on page
? ? ? ?
Installer Signature
Placing the DS3 Transport In Service through the HXU-357
Step
Procedure
1
From the Configuration Management submenu, press
Mode.
For more information on navigating through the menu system, refer to the procedures
detailed in
Menu" on page
2
Press
1
and then press
3
Press
1
and then press
the DS3 configuration settings.
4
Exit the Network Status screen by pressing
5
If you plan to install a fan assembly, proceed to
otherwise, proceed to
"Installing a Line Unit (HLU)" on page
? ? ? ?
Installer Signature
42
1
and then press
6
"Setting Up Basic HXU-357 System Parameters in the System Administration
40.
ENTER
to select DS3 Service Mode.
ENTER
to set to In-Service. The In-Service Mode prevents any changes to
ESC
and then pressing
"Installing a Fan Assembly (Optional)" on page
January 12, 2001
ENTER
to select Configure
39.
42.
and then press
ENTER
to select Service
ENTER
.
63.
LTPH-SM-1014-03, Issue 3
Installer Check ü ü ü ü
H
H
H
H
Date
Installer Check ü ü ü ü
H
H
H
H
H
61;
Date
HMS-358 List 1 and List 2
Advertisement
Table of Contents
