Connecting The Network Interface; Network Interface Connections; Pinouts For 10Base-2 Interface - ADC Soneplex HMS-358 Installation And Verification Manual

Connecting the Network Interface

C
ONNECTING THE
10Base2
HMU
10BaseT HMU 10BaseT HMU
For all network connections, shielded cables are required.
For 10BASE-T connections, Category-5 shielded cables are required.
Step Procedure
Whenever installing or removing units from the HMS-358 chassis, be sure to wear an
antistatic wrist strap and connect it to the ESD strap input.
1 Determine the network interface for your application
10BASE-2 (coaxial)
10BASE-T (Category-5)
DB-25 (modem)
2 Connect the appropriate network interface cable (10BASE-2, 10BASE-T, or DB-25) coming from the
network to the appropriate network interface connector located on the rear of the shelf (see
Figure 15).
For connector pinouts, see
3 If your network uses a 10BASE-T interface, proceed to
page 25. If your network uses a 10BASE-2 interface, proceed to
Configuration" on page
? ? ? ?
Installer Signature
22
N
ETWORK
OSS RS-232 PORT OSS RS-232 PORT
Figure 15. Network Interface Connections
Table 5
28.
Table 5. Pinouts for 10BASE-2 Interface
Pin Description
Center LAN
Shield LAN-
January 12, 2001
I
NTERFACE
below through Table 8 on page
"Setting Up a 10BASE-T Configuration" on
"Setting Up a 10BASE-2
LTPH-SM-1014-03, Issue 3
AUX RS-232 PORT
Installer Check ü ü ü ü
Select One
H
H
H
H
24.
H
Date
HMS-358 List 1 and List 2