Ramsey Electronics WILDCAT 80,000 LB Series Operating, Service And Maintenance Manual page 13

22. By removing snap ring #58 and ball bearing #31, the input shaft #22 may be removed.
23. To remove the motor end bearing #18, support drum #14 with a nylon strap or chain and hoist.
Lift on the drum to tension the strap. Remove (6) bolts #67 and (6) nuts #68 attaching the end
bearing to the mounting angles #6 and #7. The motor end bearing #18 will be supported on the
output shaft end and may be slid off using a nylon strap and hoist to lift it.
22
31
58
67
18
68
11
14
7
6
67
OM-914207-0211-D