Cable Installation - Ramsey Electronics WILDCAT 80,000 LB Series Operating, Service And Maintenance Manual

CABLE INSTALLATION

1. Unwind cable by rolling it out along the ground to prevent kinking. Securely wrap end of wire
rope, opposite hook, with plastic or similar tape to prevent fraying.
2. Place taped end of cable into slot on drum flange and bend into track on drum flange. Secure
using supplied u-bolt #62 and (2) nuts.
3. Carefully run the winch in the "reel-in" direction. Keeping tension on end of cable, spool all the
cable onto the cable drum, taking care to form neatly wrapped layers.
4. After installing cable, band brake is used to prevent bird nesting while pulling out cable, when
clutch is disengaged.
BEND INTO TRACK
AS SHOWN
62
3
62
INSERT END OF CABLE
INTO SLOT AS SHOWN
OM-914207-0211-D