Table of Contents
Advertisement
Maintenance
Inspecting V-Belt
The V-belt is designed to last for a long time and is not normally replaced. However, if the V-belt is
cracked, gouged or broken, it should be replaced.
Slide fl at belt off large pulley as shown in Removing Belt.
To remove V-belt, slide back of belt over pulley (A). Then fi rmly pull on belt and "snap" it out.
Discard used belt.
A
To install new belt (with lettering on outside of belt), slide back of belt over pulley and pull front of
B
belt toward groove (B) next to pulley. Belt will "pop" into place.
Insert agitator brush roll through belt and position belt in groove (A) on agitator brush roll.
A
V-Belt: What to buy
Use only genuine VAX belts with your cleaner
www.vax.com.au
13
Advertisement
Table of Contents
