Related Manuals for Vax Vivality Plus V-0072
Summary of Contents for Vax Vivality Plus V-0072
- Page 1 V-0072 easy guide Please read carefully before using your V-0072. Always fully extend mains cable before use.
- Page 2 Important information - Save these instructions Congratulations on the purchase of your V-0072 cylinder cleaner. In order to get the best performance from this product, please read and retain these instructions. When using electrical appliances, in order to reduce the risk of fire, electric shock and/or injury to persons, basic safety precautions should be followed, including the following: •...
-
Page 3: Assembling The Appliance
Assembling the appliance fig. 1 The telescopic extension tubes can be lengthened by pressing the button down and pulling the tubes apart. fig. 2 To attach the flexible hose to the vacuum cleaner, push the connecting end of the flexible hose into the attachment point on the vacuum cleaner. - Page 4 Assembling the easy-reach tool system Your V-0072 has been equipped with easily accessible tool storage. To assemble this, please follow these instructions. fig. 3 The tool storage system fixing bracket is already in place on the extension tube. Insert the holding tubes as shown until the tubes click into place. fig.
- Page 5 Adjusting the cleaning head for carpets & hard floors fig. 5 Hard floor position (tiles, parquet floors, etc) – The cleaning head bristles must be in the lower position. Press on the rocker switch to lower them. fig. 6 Carpet or rug position – The cleaning head bristles should be raised. Press the rocker switch to lift them.
- Page 6 How to use your V-0072 Fully extend the mains cable and plug it into a standard domestic outlet. fig. 7 Press the foot pedal to start the vacuum cleaner. To stop it, press the pedal again. fig. 8 Press the foot pedal to recoil the power lead. fig.
- Page 7 How to use your V-0072 fig. 10 If you wish to pause briefly during vacuuming i.e. to move a piece of furniture or a rug, use the special parking position on your vacuum cleaner as shown. Slide the hook attached to the cleaning head into the slot on the rear of the appliance.
-
Page 8: To Change The Dust Bag
To change the dust bag Your appliance is equipped with a dust bag. If you notice that the vacuum cleaner seems to be less efficient than usual, check the dust indicator by selecting the maximum power and lifting the vacuum cleaning head off of the floor. If it turns red, change the dust bag. - Page 9 To change the filters fig. 15 Motor protection filter: The filter is located in the dust bag compartment and protects the motor from dust. To access this filter, remove the grille from the machine and replace it with a new one. We recommend changing the filter after 5 bag changes or when it appears soiled.
- Page 10 Dust bag indicator fig. 17 When the indicator turns red or when the suction power reduces substantially, this indicates that you should empty the dust bag. fig. 18 When the bag is not full, the indicator will show blue. Attention: If after emptying the dust bag, the indicator stays red, this could be for several reasons: 1, The suction passages may be blocked –...
- Page 11 This page has been left intentionally blank...
- Page 12 If you have queries or concerns about using your VAX, call the HELP LINE. Calls are charged at the UK national rate. Please make a note of the serial number and model number of your VAX before calling. VAX Limited, Kingswood Road, Hampton Lovett, Droitwich, Worcestershire WR9 0QH, UK...