Vax Power Plus 6 User Manual page 10

Maintenance
HEPA Final Filter: How to Clean
Disconnect cleaner from electrical outlet. Do not use cleaner without dust bin or fi lters in place.
With fi ngers in slots, pull fi lter frame (A) straight out.
Dirt and debris can be cleaned from the fi lter cartridge by brushing with the cleaner's
A
combination tool.
DO NOT RINSE OR WASH the HEPA fi lter cartridge.
Slide back into position on cleaner.
Clearing Blockages
Disconnect cleaner from electrical outlet.
Low suction or pick up may be due to a blockage in the system. Refer to the following steps to check for blockages continuing
with each step until the blockage is found:
Fullness of
Dust Bin
Check fullness of dust
bin; empty if needed
Check Hose
Inlet
Turn cleaner OFF and unplug.
If blockage can be seen in tube
(A), remove 5 screws using a
Phillips screwdriver.
Pull tube from cleaner, remove
blockage.
A
Reposition tube on back of
cleaner, replace 5 screws.
10
Check Airfl ow
Path
A
Plug cleaner in and turn ON. Check
for suction at end of hose (A). If there is
suction turn cleaner OFF and unplug.
Check connection at hose tube (B);
remove any blockage.
Checking Under
Bottom Plate
AU: 1300 361 505 / NZ: 0800 800 900
Check Secondary
Filter
B
Remove and clean secondary fi lter
Replace fi lter.
Turn cleaner OFF and unplug.
Remove bottom plate and agitator
brush roll.
Look into opening (A), in channels
(B) and round liner (C) and
remove any accumulated debris.
C B A Replace agitator brush roll and
bottom plate.
Vax Service line