Replacing The Belt; Removing Blockage From Hose - Vax ACTION 602 U86-AN-BE Get Started

Let's talk technical
Removing a blockage from the hose
Pull hose out of
hose to machine
connector.

Replacing the belt

Lie vacuum cleaner
on its back exposing
brush bars. Use a cross
head screwdriver.
Undo 5 screws.
Place belt on rounded
area of brush bar
without bristles.
Lift clip under the Pull latch out and
hose inlet. remove hose.
Lift to remove
brushbar cover.
Line up right side of
brush bar with base,
push into place. Lift and
push left side of brush
bar until clicks into place.
Remove any
blockage by
inserting wire coat
hanger into hose.
Lift to remove brush
bar. Remove and
dispose of old belt.
Line up brush bar
cover, push until it
clicks into place.
If the brushbar does not rotate
Replace 5 screws
easily then the belt may not
and tighten.
have been fitted correctly. Make
sure the belt is not twisted.
WARNING
Line up latch,
push until it clicks
into place.
Clean any debris from
spindle. Place new
belt on spindle.