Table of Contents
Advertisement
Initial Assembly
Your Kalamazoo Gaucho Grill requires only minor assembly, but many parts are individually wrapped
to prevent damage. The only tool required is an hex key (provided) to mount the wheel. In the case
of the K750GS model, you may also need to install the left side shelf.
A.
Mount the wheel. First, set rectangular key stock
into slot at the end of the spindle, see inset.
(The spindle protrudes from right end of the
upper cross member) Visually align the spindle
key with the square keyway inside the hub of
the wheel. Place the wheel hub on the spindle,
and rotate slowly to locate the keyway. Slide the
wheel all the way onto the spindle. Insert the
hub bolt through the wheel and into the spindle,
tightening with the supplied large hex key. Use
supplied set screw and small hex key to tighten
the key stock in place.
B.
Insert the three laser-cut stainless steel fire
grates into the firebox of the grill so they rest
on the ledges inside and are positioned directly
above the burners. The square holes should be
positioned slightly behind the burner locations.
C.
Place the grill grates into the grill rack, or...
D.
Remove one, two or three grill grates in order to
make room for the rotisserie spit. The rotisserie
spit can be used in conjunction with one or two
grill grates if the length of the food on the spit
allows room. Insert the rotisserie spit by sliding
the pointed end through the hole in the left side
of the grill rack first, and then sliding other end
into the hex socket in the right side of the grill
rack (see Figure 10).
E.
If not already on the unit, mount the CONTROL
KNOBS on the valve posts.
F.
Install the firebox ash chute gate by sliding it over
the guides at the bottom of the firebox inside the
lower cabinet.
WARNING: Always be sure the chute is closed
when the grill is in operation. Never touch the
chute gate while the grill is hot. Wait 24 hours
after a fire before opening the chute.
G.
Place the ash bin in the cabinet, seated between
the posts mounted in the floor.
WARNING: Never touch or empty the ash bin
when the grill is hot. Always wait at least 24 hours
before emptying the ash bin.
22
A
K750GS Model Only:
H.
Place the cooktop burner diffusion caps on the
cooktop burners.
I.
Place the cooktop burner grid on the cooktop
burner tray.
J.
Place the cooktop cover over the cooktop.
K.
Place an LP cylinder (not included) in the side
cabinet and secure with chain.
KalamazooGourmet.com
FIGURE 5
D
C
B
E
F
G
+1.800.868.1699
J
H
A
E
K
I
23
Advertisement
Table of Contents
