Table of Contents
Advertisement
9.6.1.2.2 Factory Calibrate
Factory calibration is available for the SS-015 process inputs. Clearing this bit will disable the
factory calibration values.
9.6.1.2.3 Writeable
The writeable bit is cleared, indicating that the sensor values may not be overwritten.
9.6.1.3 Process Input Configuration
7
Available
0
9.6.1.3.1 Sensor Range / Type
9.6.1.3.2 Lock
If set, the user-specified units of measure string (4 character maximum) will be used in place of
the default units of measure.
9.6.1.3.3 Apply Scaling
If set, the user-defined Offset, and Gain values will be used to adjust the sensor reading:
9.6.1.3.4 Assigned
The Assigned bit will always read as 0. Refer to the Smart Sensor Device Interface
documentation for further information.
9.6.1.3.5 Available
The Available bit will always read as 0. Refer to the Smart Sensor Device Interface
documentation for further information.
9.6.2 Process Device Byte
The Sensor Device field determines the signal types for each of the channel bits.
A
7
6
5
1
X
0
9.6.3 Process Sensor Parameters
There are no Process Sensor Parameters.
Process Input Configuration
6
5
Channel
Scaling
0*
?
Sensor
Sensor Input
Range/Type
Type (Range)
0x01
0-24 mA
0x03
0-1.0 Vdc
0x09
0-2.0 Vdc
Result = (Raw Reading * Gain) + Offset
Process Device Byte
(Analog Input)
4
3
2
1
0
Description
0
0
0
0
0
Single Ended
4
3
Lock
Sensor Range / Type
?
Measurement Type
0x13
Current (mA)
0x11
Millivolts (mV)
0x11
Millivolts (mV)
2
1
0
(See Below)
31 |
P a g e
Advertisement
Table of Contents
