Before Using The Adms-8 Ft2Dr/De Programmer; Using The Adms-8 Software - Yaesu ADMS-8 Operation Manual

Before using the ADMS-8 FT2DR/DE Programmer

When using the optional SCU-19 PC USB connection cable, or the SCU-16 USB serial adaptation
cable, be sure to install the designated driver before connecting either cable to the computer.
Select the communication port that is connected to the FT2DR/DE.
Click the left mouse button on the "COM port Settings" item in the "Communications" menu to open
the "COM Port Settings" window.
Click the left mouse button on the "▼" button to display the COM Port List, and then click the left
mouse button on the communication port that is connected to the FT2DR/DE.
When using the SCU-19 or SCU-16, open the Device Manager on the computer and then click the
port (COM or LPT) to select the port number (COM**) displayed as Prolific USB-to-Serial Comm Port
(COM**).
If Prolific USB-to-Serial Comm Port is not displayed in the COM port list, the driver for SCU-19 or
SCU-16 is not installed correctly. Install the device driver correctly to the computer.
After correctly installing the SCU-19 or SCU-16 drivers, if the COM Port number is not correct and the
popup message "The port COMxx does not exist" is displayed click OK. Open [Device Manager] and
find the correct COM Port number. Then choose the correct COM Port number from the list, or type
the correct COM Port number. Then click the [Determine] button to save the setting.

Using the ADMS-8 software

To enable the FT2DR/DE clone mode for use with the ADMS-8 software, use the following procedure:
1. Turn FT2DR/DE power OFF.
2. While pressing the key turn the power ON.
3. To acquire data from the FT2DR/DE, touch "RECEIVE". To transfer data to the FT2DR/DE, touch
"SEND".
7