Setting The Template Items; Memories; Priority Ch; Receive Frequency / Transmit Frequency - Yaesu ADMS-8 Operation Manual

Setting the Template Items

Memories

Enter and edit the frequencies you normally use to the memory channels. Up to 900 channels can be
registered.
Descriptions for each channel item (column) are as follows:
Descriptions for each item are as follows.

Priority CH

While Dual Watch is functioning, this channel is designated as the priority channel to be monitored
before other channels. Only one normal memory channel can be set as Priority CH. Tick the
checkbox of the desired channel.

Receive Frequency / Transmit Frequency

Enter the RX / TX frequency.
Enter the desired receive/transmit frequency. When the frequency entry is complete, use the →
key to move the curser to the right and subsequently configure the additional detail settings for the
channel. The receive and transmit frequencies can be set separately.
To enter the transmit frequency for the next channel, press the ENTER or ↓ key. The cursor will move
to the next channel.

Offset Frequency

When a transmit frequency is not entered, transmission will be performed at a frequency obtained by
adding/subtracting the offset frequency to/from the receive frequency.

Offset Direction

Set the frequency shift direction.
• -RPT
The transmit frequency is shifted to the minus offset.
24