Operating Mode; Name; Tone Mode; Ctcss Frequency - Yaesu ADMS-8 Operation Manual

• +RPT
The transmit frequency is shifted to the plus offset.
• -/+
The transmit frequency is not shifted.

Operating MODE

Select the operating mode for receive channel.
When entering a receive frequency, this item is automatically set to the operating mode that is most
suitable for the frequency. The setting may also be changed as needed.
The AM and FM broadcast band frequency ranges are automatically set by default and are not
changeable.
• FM
Use for normal bandwidth ham radio and advisory radio.
• AM
Use this mode for receiving the Air band radio, etc.
• NFM
Use the narrow bandwidth for ham radio and advisory radio.
• WFM
Use for FM broadcasting.

Name

Enter the desired memory name (up to 16 digits).

Tone Mode

This item selects the Audio Squelch Code type.

CTCSS Frequency

This item selects the Tone Frequency of the Tone Squelch.

DCS Code

Select the DCS code when DCS is set.

DCS Polarity

Change the phase inversion of the DCS code for receive/transmit. When communication using
the DCS code cannot be achieved, changing the phase inversion might enable the DCS code
communication.

User CTCSS

Select the idle line frequency to remove signals such as idle line signals used by private railways and
control signals of MCA radio system.

TX Power

This item selects the TX Power.

Skip

Select the scanning condition for receiving channels.
• OFF
Performs scanning according to the set mode basic setting –SCAN RESUME.
• SKIP
Skips the designated memory channels during scanning.
25