Send Data To Ft2D; Get Data From Sd Card - Yaesu ADMS-8 Operation Manual

Send Data to FT2D

This command downloads the ADMS-8 data from the computer to the FT2DR/DE.
Click the left mouse button on the "Save Data to FT2DR/DE" parameter in the "Communications"
menu. The transmission procedure screen will open.
To load a previously created data file to the FT2DR/DE, click the "Open" parameter in the "File"
menu, and open the desired file before performing the send data operation above.
Connect the supplied SCU-19 or SCU-16 programming cable between the FT2DR/DE and the
Personnel Computer.
Follow the on-screen instructions to transmit data to the FT2DR/DE. After the data transmission
completes, the FT2DR/DE will automatically start up in accordance with the set data.
* Never disconnect SCU-19 or SCU-16 programming cable while data transmission is in progress.
* Pay careful attention to the power cable and the connections to the FT2DR/DE and the computer,
so as not to lose the power during data reception/transmission.

Get Data From SD Card

This command imports the settings data from the microSD memory card to the ADMS-8 programmer,
and creates a new data file.
Click the left mouse button on the "Get Data from SD card" parameter in the "Communications"
menu, the data import procedure screen will open.
Insert the microSD memory card with the saved data from FT2DR/DE to the computer.
Select the data to import from the microSD memory card.
Follow the on-screen instructions to select the desired file and then click "Open" to import the data
file.
When the data transfer is complete, the template screen which was imported from the FT2DR/DE via
the microSD memory card will appear on the computer screen.
This data may be edited using the computer.
15