Siemens Wireless Room Sensor Solution User Manual page 11

WRS Display
The WRS display may show three different views, depending on the display mode:
• Current Temperature and Occupancy Mode (see Figure 3). Shown on both WRS models with
a display, the LCD panel can be configured to always show the information or temporarily show
the information only after a button is pushed.
When an HMI cable is inserted into the WRS, the current temperature and occupancy mode view is
shown along with the
• Setpoint (see Figure 4). This view is available on full-featured WRS models only and is shown after
the + or − button is pushed.
• Diagnostics (see Figure 5). This information is shown after an RTS passkey (P/N 544–643) is
inserted in the WRS RJ-11 port of either of the two WRS models with a display.
represents the percentage of WRS communications that were successfully completed:
4 bars = 100% to 99.5
3 bars = 99.5% to 99%
2 bars = 99% to 98%
Revision Date: July 10, 2008
Siemens Building Technologies, Inc.
Figure 3. Current Temperature and Occupancy Mode View.
and
Figure 5. Diagnostics (Passkey) View.
does not display real-time wireless communication status. It is updated every 60 seconds.
OCCUPIED MODE
UNOCCUPIED MODE
icons (see below for details on these icons).
OCCUPIED MODE
UNOCCUPIED MODE
SETPOINT INDICATOR
Figure 4. Setpoint View.
RF STRENGTH
BATTERY VOLTAGE
TEC ADDRESS
TEC ADDRESS
1 bar = 98% to 96%
0 bar = 96% to 0%
Wireless Room Sensor Solution
(71 F)
(11)
11