Removing Transportation Safety Bolts; Connecting To Water Supply - Beko B3D59644UG User Manual

• Cover B and the Cap are optional. If avail-
able, attach cover B and the Cap.
Cover B
Rest the tabs of Cover B against the lower
panel. Complete the assembly by rotating
the cover.
Cap
Insert the cap by pushing it with your finger.
4.3 Removing Transportation
Safety Bolts
a. Loosen all transportation safety bolts with
an appropriate wrench until they turn
freely.
b. Bend the inner part by pressing it at the
grip areas and pull the part out.
c. Attach the plastic covers supplied in the
User Manual bag into the holes on the
rear panel.
WARNING
Remove the transportation safety
bolts before operating the product.
Otherwise, the product will get dam-
aged.
WARNING
Keep the transportation safety bolts
in a safe place to reuse when the
product needs to be moved again in
the future.
Install the transportation safety bolts
in reverse order of the disassembly
procedure.
Never move the product without the
transportation safety bolts properly
fixed in place.

4.4 Connecting to Water Supply

WARNING
The water pressure required for the
operation of the product is between
1-10 bars (0.1-1 MPa). To ensure a
smooth operation of the machine,
10 - 80 liters of water shall be sup-
plied in a minute from a fully opened
tap. If the water pressure is higher,
install a pressure reducing valve.
WARNING
Models with a single water inlet shall
not be connected to the hot water
tap. In such a case the laundry will
get damaged or the product will
switch to protection mode and will
not operate.
Do not use old or used water inlet
hoses on a new product. It may
cause water leakage from your ma-
chine and stain your laundry.
a. Connect the special hose supplied with
the product to the water inlet on the
product.
WARNING
Make sure that the cold water con-
nection is performed correctly during
the installation of the product. Other-
wise, your laundry may come out as
hot at the end of the washing cycle
and thus they may be worn.
EN / 15