Electrical Connection; Handling The Product - Beko B3D59644UG User Manual

4.7 Electrical Connection

Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall
not be responsible for the damages that
shall be incurred due to using the product
without grounding according to local regula-
tions.
• Connection must comply with national
regulations.
• The electrical connection cable infrastruc-
ture of the product must be adequate and
suitable for product requirements. It is re-
commended to use a Ground Fault Circuit
Breaker (GFCI).
• Power cable plug must be within easy
reach after installation.
• If the current supply to the fuse or breaker
in the house is less than 13 Amps, have a
qualified electrician install a 13 amp sup-
ply.
• The voltage specified in the "Technical
specifications" section must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs. Overheating and
burning may occur due to the connecting
cable.
Damaged power cables should be
replaced by the authorised service in
order to prevent possible danger.
Important
Fitting a different plug:
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termin-
als on your plug, proceed as follows:
a. Connect the green - yellow or green
(earth) wire to the terminal in the plug
marked 'E' or with the symbol f or col-
oured green and yellow or green.
b. Connect the blue (neutral) wire to the ter-
minal in the plug marked 'N' or coloured
black.
c. Connect the brown (live) wire to the ter-
minal in the plug marked 'L' or coloured
red.
With the alternative plugs a 13 A fuse must
be fitted either in the plug or adaptor or in
the main fuse box. If in doubt contact a qual-
ified electrician.

4.8 Handling the Product

a. Unplug the product before handling it.
b. Disconnect the water outlet and water
main connections. 3 Drain all the water
that remains in the product. See Draining
Remaining Water and Cleaning the Pump
Filter
c. Install the shipping bolts in reverse order
of the disassembly procedure. See Re-
moving the Shipping Bolts
Never carry the product without the
shipping bolts properly attached!
Your product is so heavy that it shall
not be carried by one person.
Your product shall be carried by two
people and more care shall be taken
on the stairs as it is a heavy product.
If the product falls on you, it may
cause injury.
The packaging materials are danger-
ous for children. Keep packaging
materials at a safe place away from
the reach of children.
EN / 17