Removal Of 6-Point Cradle System - Joerns Hoyer Calibre User Instruction Manual

Hoyer
®
English
Calibre

8. Removal of 6-point Cradle System

foLLoW THeSe inSTruCTionS eXaCTLY
Your Calibre lift uses the 6-point cradle. The removal of this systems is completed by the use
of a quick-release pin. This is done quickly and easily, but you must read the following safety
instructions to ensure the 6-point cradle is safely locked into position before use.
Connection
Warning
Two persons are required to fit the 6-point cradle or a support table can be used.
To connect, raise the 6-point cradle up toward the boom slot.
Insert the pin sleeve through the plastic end cap to support the 6-point cradle.
Once aligned in the boom slot, reinsert the quick-release pin fully into the sleeve until it locks into
position. YOU MUST CHECK THAT THE PIN IS SECURELY FITTED.
To do this, press your finger into the barbed end. If the pin remains stationary the lift is safe to use.
19