Worklight; General Information About The Worklight; Dismounting/Replacing The Worklight - Dräger Medical Babytherm 8004 Technical Documentation Manual

Babytherm 8004/8010
1

Worklight

1.1 General information
about the worklight
1.2 Dismounting/replac-
ing the worklight
6132.300
The large energy-saving lamp of the radiant heater must be replaced if it is
faulty.
• Plug the Babytherm power cord into the mains socket-outlet.
• Set the electrical height adjustment (option) of the Babytherm to the low-
est position.
• Unplug the Babytherm power cord from the mains socket-outlet.
WARNING
Risk of burns! The infrared rods or the protective screen may cause
burns if touched shortly after use of the radiant heater. Allow the radi-
ant heater to cool off for at least 15 minutes before servicing.
• Swivel the radiant heater in your direction.
• Remove the faulty energy-saving lamp 1 (worklight) by holding the lamp
mount 2 and by turning the energy-saving lamp counter-clockwise.
Radiant heater actuators (underside); removing the worklight.
Fig. 1:
• Fit the new energy-saving lamp 1 (worklight) by holding the lamp mount 2
and by turning the energy-saving lamp clockwise (hand-tight).
• Plug the Babytherm power cord into the mains socket-outlet.
• Switch the Babytherm on.
• Press the worklight button on the control unit.
Both energy-saving lamps (worklight and nightlight) of the radiant heater
come on.
Maintenance Procedures
59