First Use; Lighting Instructions - EXPERT GRILL XG17-096-034-17 Owner's Manual

(Figure 2).
3. Spoon the leak detection check solution on all "X" locations
(Figure 5).
a. If any bubbles appear, remove the LP gas tank and reconnect,
making sure the connection is secure.
b. If you continue to see bubbles after several attempts, remove
the LP gas tank per "Disconnecting LP Gas Tank" section, and
contact 1-855-328-4769 for assistance.
c. If no bubbles appear after one minute, turn regulator/control
knob to the "OFF" position, wipe away solution and proceed.

First Use

1. Make sure all labels, packaging and protective films have
been removed from the grill.
2. Remove manufacturing oils before cooking on this grill for the
first time by operating the grill for at least 15 minutes on (HIGH)
at control knob with the lid closed. This will "heat clean" the internal
parts and dissipate odors.

Lighting Instructions

CAUTION: Keep outdoor gas cooking appliance area
clear and free from combustible materials, gasoline
and other flammable vapors and liquids.
CAUTION: Do NOT obstruct the flow of combustion
and ventilation air.
CAUTION: Check and clean burner/venturi tubes for
insects and insect nests. A clogged tube can lead to a
fire.
CAUTION: Attempting to light the burner with the lid
closed may cause an explosion.
CAUTION: Always open legs completely and secure
in place before opening lid orlighting grill.
1. Open lid.
2. Check for obstructions of airflow to the burners. Spiders,
insects and webs can clog the burner/venturi tube. A clogged burner/venturi tube can lead to a fire.
3. Connect LP gas tank per "Connecting LP Gas Tank" section.
4. Make sure regulator/control knob is in the "OFF" position (Figure 2).
5. Insert a long lit match close to the burner through the hole in bottom bowl near the lock (Figure 6).
6. Turn the control knob to (HIGH).
7. If ignition does not occur in 5 seconds, turn regulator/control knob to "OFF" position, wait 5 minutes
and repeat lighting procedure.
8. After lighting, observe the burner flame. Make sure all burner ports are lit and flame height matches
illustration (Figure 7).
Caution: If burner flame goes out during operation, immediately turn the regulator/
control knob " OFF" and open lid to let the gas clear for 5 minutes before re-lighting.
Model No.
Page 16
XG17-096-034-17
Figure 5
Figure 6
Figure 7