PACH & COMPANY QUANTUM QC Series Manual page 32

QC SERIES MANUAL
5.4 Opening Door Using Card, Temporary Card, and Special Card
The Quantum QC Series has built-in card reader. The door can be access using UFOB, UCLAM or UISO.
Card Standard Operation is used to open the door and door will be closed automatically, see
Temporary Card is used for limited of times, maximum 10 times then the card will be expired, see
Special Card is used to unlock hold door and then use same card to lock the door, see
Pach and Company UFOB, UCLAM and UISO must be used to have access to the card reader. Other
manufacturers card will not work.
Swipe the card or keyfob as shown below. The card reader antenna is mounted behind the black square window.
5.5 Extending Talk Time
The talk time timer is set on
can be extended more another full cycle by pressing #
5.6 Call the System from Remote Location
1. The system must be install in
wiring Diagram
2. Function code 38
3. Function code 39
4. You must have the system phone number
5. Call the system phone number if the system answered, short beep will be heard.
6. Press # then 4-digit Master code (default is 0000), short beep will be heard if master code is accepted
7. Press * to establish two ways communication
8. Press 9 to release relay 1 (door 1) or 8 to release relay 2 (door 2).
file:///C|/PACH-CO.COM-2022-B/online_manual/qc_series_manual.htm[4/27/2022 8:58:09 AM]
function code 27. The warning beep will be heard one minute before the talk time is expired. It
Intercom and Call Forwarding Mode Wiring Diagram
must be set at least for 1 ring
must be set to 1
function code 10
function code 35
function code 36
or Call Forwarding Mode