Filter Settings - Korg Speaker System User Manual

P3: Edit-Filter Filter settings
The filter allows you to diminish or emphasize speci-
fied frequency areas of the multisample selected for the
oscillator. The tone of the sound will depend signifi-
cantly on the filter settings.
The TRITON lets you choose between two types of fil-
ter for each oscillator. Filter 1 is used for OSC1, and Fil-
ter 2 is used for OSC2. If "OSC Mode" is Single or
Drums, only Filter 1 will be available.
Filter EG and LFO can be used to produce time-vary-
ing changes in the filter.
Level
Overtones included
in the original multisample
Frequency (pitch)
Filter 1 tab
Filter Type, Filter A, Filter B
Select the type of filter, and specify the "Frequency"
(cutoff frequency) and "Resonance" (resonance level).
• Low Pass Resonance (24 dB/oct low pass filter
with resonance): Make settings for filter A.
• Low Pass & High Pass (12 dB/oct low pass filter
and 12 dB/oct high pass filter in series connection):
Make low pass filter settings in filter A, and high
pass filter settings in filter B.
Low pass filter
This is the most common type of filter, which passes
the low frequency range and cuts the high frequency
range. When the overtones of the high range are cut, a
bright sound will become darker (more mellow).
24 dB/oct and 12 dB/oct refer to the steepness of the
cut. 24 dB/oct means that the gain will decrease 24 dB
in one octave (i.e., as the frequency doubles). A 12 dB/
oct filter would decrease the gain 12 dB in one octave.
The 24 dB/oct filter produces a steeper cut.
48
Filter characteristics
This area of
Level
overtones will
be diminished
Filter
Overtones after
passing through
the filter
Frequency (pitch)
Low Pass
Level
12dB/oct
24dB/oct
Frequency
High pass filter
This type of filter passes the high frequency range and
cuts the low frequency range. Use this when you wish
to make the sound thinner. However if the cutoff fre-
quency (Frequency) is raised excessively high, the vol-
ume will become very low.
Resonance
When "Resonance" is set to a higher value, the over-
tones in the region of the cutoff frequency will be
boosted as shown in the diagram below, giving a dis-
tinctive character to the sound.
When resonance is applied
Low Pass
Level
Low resonance value
Filter 1 Mod. tab
Controllers and the filter EG can be used to modulate
the filter cutoff frequency that was specified in the Fil-
ter 1 tab. By using a controller to vary the tone or by
using an EG to create time-varying changes, you can
add a rich variety of tonal change to the sound.
Keyboard Track
This varies the cutoff frequency according to the key-
board location that you play.
• When "Ramp Low" is set to a positive (+) value,
the cutoff frequency will rise as you play lower on
the keyboard, making the sound brighter. When
set to a negative (–) value, the cutoff frequency will
fall as you play lower on the keyboard, making the
sound darker.
• When "Ramp High" is set to a positive (+) value,
the cutoff frequency will rise as you play higher on
the keyboard, making the sound brighter. When
set to a negative (–) value, the cutoff frequency will
fall as you play higher on the keyboard, making
the sound darker.
High Pass
Level
12dB/oct
Frequency
High resonance value