Korg Speaker System User Manual page 50

If you press the popup button, all multisamples of
internal ROM will be displayed, grouped into fif-
teen categories.
Use the tabs at left and right to select a category,
and select the desired multisample.
About High/Low
You can specify two multisamples for an oscillator, and
use velocity (keyboard playing dynamics) to switch
between the two multisamples. This capability is called
"velocity multisample switching."
1 Select different multisamples for "High" and
"Low."
2 Set the "Velocity M.Sample SW Lo → Hi" parame-
ter to set a value of (for example) 100 for OSC1.
The Low and High multisamples will be switched
at this velocity value.
3 Play the keyboard softly, and the multisample
specified for "Low" will sound.
4 Play the keyboard strongly, and the multisample
specified for "High" will sound.
5 Adjust the "Lvl" (level) for "High" and "Low"
multisamples to set their volume balance.
If you do not wish to use this function, set the
"Velocity M.Sample SW Lo → Hi" value to 001.
Only the High multisample will sound.
Rev (Reverse) check box
If this is checked, the multisample will be played back-
ward. This can produce interesting results when used
on sound-effects, etc. Normally you will not check this.
When "Oscillator Mode" = Double
To use OSC2, set "Oscillator Mode" to Double in the
Program Basic tab.
In the same way as for OSC1, you can set High and
Low multisamples for OSC2.
The playback pitch can be set independently. By using
the same multisample with slightly different "Tune"
settings, you can "detune" the oscillators to produce a
richer sound.
It will be convenient to use the page menu com-
mand "Copy Oscillator" to make the oscillator set-
tings match each other.
46
When "Oscillator Mode" = Drums
In the Program Basic tab, set "Oscillator Mode" to
Drums. When this is set to Drums, you will be able to
create a drum program.
This will select a drum kit instead of a multisample.
The TRITON provides sixteen factory preset drum kits
that are suitable for a wide variety of music. For the
drum kit names, refer to the separate Voice Name List.
Here you can only select a drum kit. To edit or create a
drum kit, use Global P5: Drum Kit (
Velocity Zone tab
Here you can specify the range of velocities that will
sound oscillators 1 and 2. In the example shown above,
the velocity ranges are as follows.
• OSC1 will sound for all velocity values.
• OSC2 will sound only for strongly played notes (64
and above).
• You can use Velocity Multisample Switching in
addition to this ( "About High/Low"). For this
example, set "OSC1" in "Velocity M.Sample SW
Lo→Hi" to 032 and "OSC2" to 096. The settings are
shown as horizontal lines in the velocity zone
display.
In this example, the multisamples will sound over
four levels.
Velocity values 001–031: sound only the OSC1 Low
Velocity values 032–063: sound only the OSC1
Velocity values 064–095: sound the OSC1 High
Velocity values 096–127: sound the OSC1 High
p.90).
multisample.
High multisample.
multisample and the
OSC2 Low multisample.
multisample and the
OSC2 High multisample.