Korg Speaker System User Manual page 8

• You can use a cue list to set up consecutive
playback of multiple songs, and specify the
number of repeats for each song.
• You can use a maximum of 20 cue lists, 200 songs,
and 100 preset patterns. One song can use as many
as 100 patterns.
• The TRITON can be used as a 16-track
multitimbral tone generator.
• Perform using the RPPR (Realtime Pattern Play/
Recording) function, and make settings for it.
Song Play mode
• Playback SMF (Standard MIDI File) data from a
floppy disk or an external SCSI device such as a
hard disk (when the separately sold EXB-SCSI
option is installed), and play along with the
playback if desired.
• Make effect settings for use in Song Play mode.
• The arpeggiator can be used while you play along
with the SMF playback.
• SMF songs can be played back in succession. You
can use the jukebox function to playback songs in
any specified order.
Sampling mode
• Sample sounds from an external audio device or
mic connected to the rear panel AUDIO INPUT
jacks. Insert effects can be applied to the external
input sound while you sample.
• Edit the waveform data you sampled or waveform
data that you loaded in Disk mode, and set loop
points etc.
• Edit multisamples consisting of two or more
samples.
• A multisample can be converted into a program, so
that a multisample created in Sampling mode can
be used in Program, Combination, Sequencer, or
Song Play modes.
Global mode
• Make settings that affect the entire TRITON, such
as master tune and global MIDI channel.
• Create drum kits (64 kits), arpeggio user patterns
(232 patterns), and user scales (16 one-octave scales
and 1 all-note scale).
• Create drum kits using the 413 internal
drumsamples (ROM). You can also use
drumsamples from an optional EXB-PCM series
board (if installed), or samples (RAM) that you
created in Sampling mode.
• Adjust the input level etc. from the AUDIO INPUT
1 and 2. These settings are valid in modes other
than Sampling mode. The TRITON's effects can be
applied to the external input sound. (The settings
for Sampling mode are made independently
within Sampling mode.)
• Set the function of the assignable pedals and
assignable switches.
• Transmit data dumps of MIDI exclusive data.
4
Disk mode
• Data of each mode can be saved and loaded using
the floppy disk drive or an external SCSI device
(when the separately sold EXB-SCSI option is
installed).
• Media such as floppy disks or hard disks (when
the separately sold EXB-SCSI option is installed)
can be formatted, and data can be managed by
copying etc.
• Korg format sample data can be loaded and saved.
Akai, AIFF, and WAVE format sample data can be
loaded.
• Songs that you created in Sequencer mode can be
saved in SMF format. SMF files can be loaded as
Sequencer mode songs.
• You can use the Data Filer function (to save/load
MIDI exclusive data).