ABI Attachments Workman XL Owner's Manual page 15

Fig 31.
Fig 33.
Tongue is upside down position
since trailer is upside down.
Fig 34.
13. Push excess wiring back into the frame. There are 2
ways to accomplish this - pushing the wire into the tongue
or into the frame of the trailer.
There are grommets on both the tongue and frame to
protect the wires from being damaged by the sharp metal
edges (Fig 35).
Email: support@abiattachments.com
Fig 32.
Both Connectors from
the tongue snap onto
the connectors on the
trailer frame only one
way.
Fig 35.
To push the big connector into the tongue, pull the tongue
grommet off the tongue and push it over the big grommet
then work the big and small connectors inside the tongue
and replace the grommet back onto the tongue. push the
remaining wires into the frame of the trailer as you pull the
tongue closer to the frame (Fig 36).
Fig 36A.
Remove grommet from tongue
and slide over big connector.
Fig 36C.
Fig 38A.
Optional Tongue
Support Bracket.
15
Grommets on tongue
and frame of trailer.
Fig 36B.
Fig 37.
Fig 38B.
Call Toll Free: 877-788-7253