ABI Attachments Workman XL Owner's Manual page 11

14. Before installing the "Piston End" (small end) of the
electric actuator lift to the crossbar, manually turn
the piston shaft counter clockwise until the piston is
completely seated in the actuator then turn the piston
shaft two complete revolutions clockwise (to prevent
piston from bottoming out during use) to set the limit
switch. Install the "Piston End" of the actuator to the
crossbar brackets. Using hardware from Packet "G",
slide one washer onto bolt. Slide bolt thru first bracket
then slide one spacer onto bolt then slide bolt thru end
of piston. Slide second spacer onto bolt then slide bolt
thru second bracket. Slide second washer onto bolt.
Thread locknut onto bolt and tighten nut using (2) 18mm
wrenches or socket set so that is it is snug against second
bracket but allows the actuator to pivot smoothly when
lifted (Fig 20A & B).
15. Connect the two wires from the actuator lift motor to
the wires from the black plastic box - they only fit one way
(Fig 21).
Fig 12.
Hardware from Packet "C".
Fig 13.
Line up pivot brackets
on rectangular frame
with axle bearings on
struts.
Email: support@abiattachments.com
Fig 14.
use hardware from
packet "D" to attach
rectangular frame/bed
rest assembly to struts.
Hardware from Packet "D".
Fig 15.
Use hardware from
packet "E" to mount
crossbar to struts.
Hardware from Packet "E".
Fig 16A.
11
Actuator brackets on
crossbar must face
toward front of bed
(toward black plastic
electrical box).
Tighten bolts on both
ends of each strut.
Call Toll Free: 877-788-7253
Fig 16B.