ABI Attachments Workman XL Owner's Manual page 14

Setup (cont'd)
Fig 26.
Align axle brackets so they are
parallel to rectangular frame before
tightening bolts.
Hardware from Packets "H".
Fig 27.
Remove lug nuts
from all 4 hubs.
Fig 29.
Valve stem must be
pointed outward
when mounting tire.
Replace lug nuts with tapered portion
of lug nut facing inward toward rim.
Visit: www.abisupport.com
Fig 28.
Bead of tire may
seperate from rim
during shipping.
Fig 30.
The other option instead of pulling the grommet off
the tongue is following the same procedure but pull
the grommet off the frame of the trailer and push the 2
connectors thru the grommet. Work the 2 connectors into
the frame of the trailer and position the grommet back
onto the frame. Push the remaining wire into the tongue
while postioning the tongue up next to the frame (Fig 37).
20. Once wiring is pushed back into the tongue and frame
and both grommets are in their correct position, have
someone hold the tongue in postion (upside down since
trailer is upside down) while the optional tongue support
bracket is placed into position (Fig 38).
WIRES ARE BEING PINCHED BETWEEN THE TONGUE
AND FRAME WHILE MOUNTING THE TONGUE AND
TONGUE SUPPORT BRACKET.
21. Bolt the tongue assembly and tongue support bracket
to the frame using hardware from packet "H - Tongue
Hardware". Slide washer onto long bolt then slide long
bolts (4) into tongue bracket. continue sliding bolts thru
trailer frame and tongue support bracket. Slide washer
onto each bolt then thread locknut onto each bolt - hand
tighten only (Fig 39). Slide washer onto short bolt then
slide short bolts (2) into tongue bracket. Continue sliding
bolts thru tongue support bracket. Slide washer onto each
bolt then thread locknut onto each bolt - hand tighten
only (Fig 40). If optional tongue support bracket is not
being used, step 13 is still the same with bracket omitted.
Once all 6 bolts and nuts are in place, tighten using (2)
18mm wrenches or socket set.
22. With the trailer still upside down, gently pull the slack
out of the wiring harness running thru the tongue out by
the ball hitch (Fig 41). Loop the excess wire around the
safty clip on the side of the ball hitch to protect the wire
harness if the ball hitch is detached from the tow vehicle
but the harness is not (Fig 42).
23. Before flipping the trailer to the upright position, make
sure there is cardboard on the ground so that the trailer
side doesn't get scratched when the trailer is flipped up on
it's edge. Flip the tailgate pin, as well as the "D" rings on
the side of the trailer to a position they won't get pinched
and bent when lifting the trailer (Fig 43). With the help of
2 people, lift the trailer from one side until the opposite
side of the trailer is resting on the cardboard (Fig 44).
24. With a person on either side of the trailer, Continue
pulling the trailer over onto its tires (Fig 45). The ABI
Workman XL Trailer is now complete(Fig 46).
14
MAKE SURE NO