Edit Tempo; Metronome; P1 Tempo Source Setting; P2 Tempo Recording - Korg D8 Owner's Manual

P1-5 Metronome type select.....................................
[refer to "Metronome type list"]
Selects a metronome type suitable for the time signa-
ture that you selected in the Time Signature setting
(P1-3).
You can change the rhythm pattern by selecting a met-
ronome type in conjunction with changing the tempo
and time signature.
P2
Metronome volume setting
P2-1 Metronome volume setting ......................[001...100]
This sets the volume of the metronome.
The value can be changed either from this page or
from EDIT METRONOME P1 (refer to p.55).

12. EDIT TEMPO

P1
Tempo source setting
TmpSrc:Map
P1-1 Tempo source select ................................... [Map, Trk]
Selects the tempo source.
Map: Tempo change will occur according to the tempo
map that was created in TEMPO P1.
Trk: Tempo change will occur according to the tempo
that was recorded by Tempo Recording (refer to EDIT
TEMPO P2).
It is not possible to select Trk until you perform tempo
recording.
After tempo recording, this will automatically be Trk.
P2
Tempo recording
By recording MIDI Clock messages, you can synchro-
nize to the MIDI Clock messages of an external
sequencer.
By recording tap tempo, you will be able to use mea-
sure units to handle a source of unknown tempo (such
as a CD) that has previously been recorded into the D8.
If the time signature changes during the song, you
must first use TEMPO P1 to create a tempo map which
includes the changes in time signature.
Tempo recording will end automatically when mem-
ory becomes full.
TempoRec œ
54
1
1
MIDIclk ?
P2-1 Tempo recording source select.........[MIDIclk, MeasTap]
Selects the source for tempo recording.
MIDIclk: MIDI Clock messages from a song recorded
on an external sequencer etc. will be recorded to create
the tempo track.
MeasTap: Taps at the beginning of each measure will
be recorded to create the tempo track. (Refer to p.35)
During tap tempo recording, the foot switch will func-
tion as the tap marker, regardless of the SYSTEM P3
setting.
After the tempo track has been created, you can set the
tempo source of P1-1 to Trk to allow tempo change
using the tempo track.
Be aware that if you re-record, the previous tempo
track will be erased. Also, since MIDI Clock and Tap
are recorded in the same place, only the last-recorded
of these two will be valid.

13. METRONOME

Metronome on/off....................................................[On, Off]
Turns the metronome on/off.
On (indicator lit): The metronome will sound during
playback and/or recording (refer to EDIT METRO-
NOME P2), according to the tempo, time signature and
metronome type that you specified as the tempo
source (refer to EDIT TEMPO P1). The metronome will
also sound while you are in TEMPO P1 or EDIT MET-
RONOME P1.
Off (indicator off): The metronome will not sound dur-
ing playback or recording. Nor will the metronome
sound while you are in TEMPO P1 or EDIT METRO-
NOME P1.
The metronome sound is output from OUTPUT L/R
and from PHONE. It is not possible to directly record
the sound of the metronome.
If you wish to record the sound of the metronome on
the D8, use an audio cable to connect the output of the
OUTPUT L/R jacks to the INPUT 1/2 jacks, and
record as usual. At this time, set the [MASTER] fader
to 0.