Applying An Effect To The Input Sound As You Record - Korg D8 Owner's Manual

When you execute the Save operation, the effect
program that previously occupied that memory
will be overwritten and lost.
14
Starting and stopping recording
15 Press the [REC] key, and then press the [PLAY] key
to begin recording. Press the [STOP] key to stop
recording. (Refer to
recording", p.11)
Listening to the recorded performance (Play-
back)
16 Move the current time to a location earlier than the
point at which you began recording. Then set the
[TRACK STATUS] of the recorded track to PLAY, and
press the [PLAY] key to begin playback. Press the
[STOP] key to stop playback. (Refer to " Listening
to the recorded performance (Playback)", p.11)
5. Applying an effect to the
input sound and record-
ing only the input sound
Here's how you can apply the D8's internal effect
to the sound of an instrument or other sound
source connected to the INPUT 1 jack or INPUT 2
jack. In this section, only the input sound is
recorded. Use this method when you wish to try a
variety of effects during playback and decide on
the final sound later.
Connecting the input device and adjusting
the level
1
Refer to " Connecting the input device and
adjusting the level" (p.11, p.12), to connect the
input device and adjust the level.
It is not possible to use the effect when recording
digitally.
Selecting the location at which the effect will
be inserted
2
Press the [EFFECT ASSIGN] key
several times to select MASTER
(Send Type) (indicator lit). With the
setting MASTER (Send Type), the
send bus will be output to the inter-
nal effect, which will be output to
the master bus.
FADER
INPUT [EQ]
HEQ LEQ
3
Adjust the following effect settings while listening
to the input sound of the instrument or other source.
Sending the input sound to the effect
4
Press the [EFFECT SEND] key several times for the
input channel where you wish to apply the effect,
"Starting and stopping
INPUT 1/2
MASTER
EFFECT
ASSIGN
E
OUTPUT
Effect
Snd
RecTrack