Table of Contents
Advertisement
1. Align the holes in the mounting plate with the holes
prepared in the door.
2. Install through-bolts through the mounting plate and
door in the top and bottom holes as shown.
3. Tighten the mounting plate onto the door with the
through-bolts.
4. Optional: With the mounting plate secured on the door,
center punch and drill a pilot hole 1 1/8" deep, center
marked in the four remaining holes on the face of the
mounting plate, for a #10 sheet metal/wood screw
(115031).
7. Install sliding plate assembly
NOTE: If the system being installed is to have Request
to Exit functionality refer to Appendix A for installation
instructions at this time.
1. Align the holes in the sliding plate assembly (514053) with
the PEM Nut standoffs on the mounting plate (514052).
2. Tighten the sliding plate assembly onto the standoffs.
Mounting Plate Asm
Sliding Plate Asm
#6-32 Screw
NOTE: The hub face of the cylindrical lock should be be-
tween the two plates on the Sliding Plate Assembly as
pictured below. If the hub face is closer to the door than
the Guide Plate (515076) remove the cylindrical lock and
unthread the outside rose liner as described in Step 4.
If the hub face extends past the Sliding Plate (515077)
remove the cylindrical lock and thread on the outside rose
liner as also described in Step 4.
Sliding Plate
(515077)
Guide Plate
(515076)
Hub Face
NOTE: For the electrified 9K trim and RQE refer to Appendices A and B for wiring instructions.
Document Number 548.0418 Rev. AX — 02/2019
8. Assemble and install core
7-pin core
For 6-pin core users only: Slide the spacer – supplied with
your 6-pin cores – over the 7-pin throw member.
For 'H' or 'HJ' functions only: Install the proper throw
member as shown above.
NOTE: If you have ordered 6-pin cores, you will get one
spacer per core with your order. Spacers are not supplied
with locks.
9. Install strike plate
1. In alignment with the center of the latchbolt, mortise the
CAUTION: The deadlocking plunger of the latchbolt must
not enter the strike plate opening. The plunger deadlocks
the latchbolt and prevents forcing the latch when the door
is closed. A gap of more than 1/8" may reduce security
and/or cause improper operation of the latchbolt.
2. Insert the strike box and secure the strike with the screws
Door face
1. Insert the throw member (or throw member and spacer)
(inside)
2. Put the control key into the core and turn the key 15
3. Put the core and throw member into the lever with the
4. Turn the key 15 degrees counterclockwise and remove the
CAUTION: Since the control key is a high-security key,
make sure to keep it protected.
2
Spacer
1
Throw
member
Control key in core
door jamb to fit the strike box and strike plate.
provided as shown.
Door jamb
into the back of the core as shown.
degrees clockwise.
control key as shown.
key.
H throw
member
HJ throw
member
Strike box
Strike plate
11
Advertisement
Table of Contents
