Shoot With Dmx Or Pyro - Magicfx STADIUMSHOT III User And Installation Manual

4. Press the compressor on/off button on top of the machine. The compressor
on/off button starts blinking.
5. After a maximum of 2.5 minutes, the pressure will be at the maximum pressure
of 8 bar. The compressor will automatically stop at the set pressure and the
compressor on/off button turns red.
If an external air source is used for the first time, follow the next steps. If an external air
source is used when the desired quick connector is installed, follow step 5 only:
1. Remove the top cover, see Section 4.1.
2. Remove the elbow part of the 3-way coupling with an adjustable open-
ended spanner.
3. Replace the end plug in the elbow with the desired quick connector suitable
for the desired quick connector.
4. Close the top cover, see Section 4.1.
5. Connect the hose from an external air source to the quick coupling. Only use
an air source with an air filter with a maximum output of 8 bar.
3.6

SHOOT WITH DMX OR PYRO

DANGER
If DMX is used, follow the next steps:
1. Make sure that the prescribed safety zone is free from persons and objects.
2. If the safety zone is free, arm the system by turning the key clockwise on the
MAGICFX
®
3. Activate the enable address. The FX LED begins to flash.
Make sure that the described safety zone is clear of people,
animals and objects. Not doing so results in death or serious
injury.
FX-ARM CONTROLLER. The FX LED lights up.
MAGICFX STADIUMSHOT III — User and Installation Manual
®
29