Advertisement
Operation Instructions
MAINTENANCE
WARNING! Operation and maintenance of the ERICO CADWELD PLUS Control Unit should only be
performed by qualified personnel.
CAUTION! Batteries should be removed prior to maintenance of the ERICO CADWELD PLUS
Control Unit.
NOTICE: Use AA lithium batteries only. Do not use NiCAD or NiMH rechargeable batteries in the Control Unit.
1.
Battery Replacement (Figure 2). To replace the
batteries, loosen the battery lid screw at the end
of the Control Unit case to remove the battery
compartment lid. Remove the battery cell holder
and replace the batteries with 8 AA lithium
batteries aligning the polarities as indicated on the
battery holder. Place the battery case back into
the Control Unit case such that the battery case
contacts align with the contacts in the case and
secure the battery lid to the case.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are registered trademarks of PENTAIR Corporation
TECHNICAL SUPPORT:
www.pentair.com
Figure 2
IPPBPLUSCU_A
4 of 4
2.
Control Unit Lead Replacement. Should the Control
Unit lead or termination clip become damaged or worn,
Replace with ERICO part number PLUSCULDQC or
PLUSCULD15QC (contact factory for replacement
lead). To replace the lead, disconnect the plugs for the
damaged or worn lead (Figure 3). Properly dispose of
the worn Control Unit lead.
Insert the plugs for the replacement lead (Figure 4)
2016 PENTAIR
Figure 3
Figure 4
Advertisement
