Bleach-Fix; Developer; Inserting The Chemical Filters - Kodak RP 30 Operator's Manual

Operator's Guide

Bleach-Fix

You can mix the working bleach-fix tank directly from the two-part concentrates. Use
two EKTACOLOR Processing Cartridge 75 units to supply the two bottles of each of
the two concentrate solutions.
CAUTION:
1. Add 12.7 L water to the tank.
2. Add the entire contents of two bottles of bleach-fix concentrate, Part A (labeled
BX-A).
3. Add the entire contents of two bottles of bleach-fix concentrate, Part B (labeled
BX-B).
The total volume in the tank is 18.0 L.

Developer

IMPORTANT:
1. Add 15.9 L water to the tank.
2. Slowly add the entire contents of two bottles of developer concentrate
(labeled CD).
3. Add 900 mL EKTACOLOR RA Developer Starter, CAT No. 102 6681.
The total volume in the tank is 18.5 L.

Inserting the Chemical Filters

1. Take the chemical filters out of the accessory pack.
2. Rinse the filters in water to remove loose fibers and attach the filters to the
holders.
3. Put them in the appropriate tanks corresponding to the colored stickers. It may
be necessary to turn the filter rods slightly so that the filters sit correctly.
3-6
Be careful to avoid contamination of the developer with
bleach-fix.
To obtain good performance, it is important to take special care in
mixing the developer tank.
KODAK PROFESSIONAL RP 30 Laser Printer