Maintenance When Required - Kodak RP 30 Operator's Manual

Maintenance When Required

Changing the Ink Ribbon on the Back Printer
When the printing on the back of the prints gets too faded, the ink ribbon must be
replaced.
1. Unscrew the locking screw (1, red) of the lane distributor.
2. Pull out the unit on the telescopic rails.
3. Unscrew the knurled screws (2) and remove the top cover of the back printer.
4. Remove the ink ribbon cartridge by slightly pushing in both sides (3).
5. Prepare the new ink ribbon cartridge:
If present remove the foil strip on the ink ribbon. The ink ribbon must be tight in
the cartridge; if necessary tighten by the knob (4) (note the direction indicated by
the arrow).
6. Insert the ink ribbon cartridge.
7. Slightly turn the knob (4) on the cartridge until the cartridge locks in audibly.
8. Push in the lane distributor unit and tighten the locking screw.
KODAK PROFESSIONAL RP 30 Laser Printer
Maintenance
8-37