Table of Contents
Advertisement
6
Sensor Setting
The following settings are available from SC-U1.
To start sensor setting, press
Caution
Pressing
Display item (unit selection)
Set the unit of turbidity to show on the SC-U1 display.
For operation, refer to the "Universal Transmitter SC-U1 Operation
Manual", "5.1 Sensor Setting" and " ◆ Display Item".
When the display item is changed, the settings of "7 4-20 mA
Setting" P.16 and "8 Relay Setting" P.18 that have set the
display item become OFF.
Caution
In addition, the values of "10 Adjustment", "Offset adjustment"
P.23, "Span adjustment" P.25, and "2-point adjustment"
P.26 are reset to the factory default values.
Set again if necessary.
Measurement item
Main
Turbidity
display
14
automatically retains the measurement value.
Main display
Turb.
Turb.
Turb.
Turb.
Turb.
.
Display item
Item
Unit
NTU
FNU
mg/L
度
No unit
Factory default
setting
Turb. NTU
Advertisement
Table of Contents
