Stihl FS-KM Instruction Manual page 6

English
Before starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the
KombiEngine and KombiTool user
manuals:
Use only an approved combination
–
of cutting attachment, deflector,
handle and harness. All parts must
be assembled properly and
securely
Check cutting attachment for
–
correct and secure assembly and
good condition
Safety devices (e. g., deflector for
–
cutting attachments, rider plate) for
damage and/or wear. Always
replace damaged parts. Do not use
the machine with a damaged
deflector or worn rider plate (if the
writing and arrows are no longer
discernible)
Do not attempt to modify the
–
controls or safety devices in any
way – only work with the deflector
fitted
Keep the handles dry and clean –
–
free from oil and dirt – this is
important for safe control of the
machine
Adjust the harness and handle(s) to
–
suit your height and reach Observe
the chapter "Fitting the Harness"
To reduce the risk of personal injury, do
not operate your power tool if it is
damaged or not properly assembled!
4
To prepare for emergencies when using
a harness: Practice setting down the
machine quickly. To avoid damage, do
not throw the unit to the ground when
practicing.
Holding and guiding the machine
Always hold the unit firmly with both
hands on the handles.
Make sure you always have a firm and
secure footing.
For versions with bike handle
Right hand on control handle, left hand
on grip on handlebar.
For versions with loop handle
For versions with loop handle and loop
handle with barrier bar, left hand on the
loop handle, right hand on the control
handle – even if you are left-handed.
Wrap your fingers and thumbs around
the handles.
While working
Make sure you always have a firm and
secure footing.
In the event of impending danger or in
an emergency, switch off the engine
immediately by moving the slide
control/stop switch/stop button to
0 or STOP.
15m (50ft)
There is a risk of accident from ejected
objects within a wide area around the
working space, so you must ensure that
there is no-one within a 15 m radius of
the machine. This distance must also be
maintained in relation to objects
(vehicles, window panes) – risk of
property damage! Even at distances
beyond 15 m, the danger cannot be
ruled out.
Avoid contact with the
cutting attachment – risk
of injury!
Check that the engine is properly idling
so that the cutting tool will not continue
rotating after you release the throttle
trigger.
Check and correct the idle speed setting
at regular intervals. If the attachment still
rotates when the engine is idling, have
FS-KM